Zero Configuration Setup - D-Link DCS-934L Quick Install Manual

Zero Configuration Setup

The Zero Configuration Setup will only work with a registered
Cloud Router and an active mydlink account. Your Cloud Router will
automatically assign your network settings (both wired and wireless) to
your camera, and add it to your mydlink account.
If you do not have a D-Link Cloud Router, skip to the Easy Setup section on
the next page.
Attach the power supply to the
1
power connector located on the back
of the DCS-934L and connect it to a
wall outlet or power strip. Power is
confirmed when the Power LED is lit.
If using an Ethernet connection:
2
Connect the included Ethernet cable
to the Ethernet port located on the
back of the DCS-934L and connect it
to your router.
If using a wireless connection: Press
and hold the WPS button on the back
of the camera for five seconds. The
blue WPS status LED will start to blink.
Then, press the WPS button on your
Cloud Router within two minutes.
From a computer connected to the
3
Internet, open a Web browser, and go
to http://www.mydlink.com. Sign
in to your mydlink account. Once
mydlink detects your camera, a Zero
Configuration notice will appear. Click
on the notification and you will see
a confirmation request. Click Yes to
add the camera to your account.
Your setup is complete!
4