Network Setting (Wireless) - Samsung RH48E User Manual

Network Setting (Wireless)

Connecting to a Wireless Network
Samsung recommends using IEEE 802.11n. When you play video over a network connection, the video
may not play smoothly.
― Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the
wireless IP sharer is currently being used by another device nearby, this will result in interference and
communication failure.
― Your product supports only the following wireless network security protocols.
If you select the Pure High-throughput (Greenfield) 802.11n mode and the Encryption type is set to
WEP, TKIP or TKIP AES (WPS2Mixed) on your AP or wireless router, Samsung products will not support
a connection in compliance with new Wi-Fi certification specifications.
― If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC
(Push Button Configuration) or PIN (Personal Identification Number). WPS will automatically configure
the SSID and WPA key in either mode.
― Connection Methods: You can setup the wireless network connection in three ways.
Auto Setup (Using the Auto Network Search function), Manual Setup,
Automatic Network Setup (Wireless)
Most wireless networks have an optional security system that requires devices that access the network
to transmit an encrypted security code called an Access or
a Pass Phrase, typically a word or a series of letters and numbers of a specified length you were asked
to enter when you set up security for your wireless network. If you use this method of setting up the
network connection, and have a
Phrase during the the automatic or manual setup process.
How to set up automatically
1
2
3
4
5
WPS(PBC)
Security key
for your wireless network, you will have to enter the Pass
Set Network type to Wireless from the Network Settings
Network
The function searches for available wireless networks. When done, it displays a list of the
available networks.
In the list of networks, press the ▲ or ▼ button to select a network, and then press the E button
twice.
― If the desired wireless router does not appear, select
― If the router cannot be found after retrying, select the
The Add Network button appears.
If the Enter password. screen appears, go to step 5. If you select a wireless router that does not
have security, go to step 7.
Enter password.
If the router has security, enter the
Security key. The Security key
is based on
page.
Refresh to search again.
Stop button.
(Security key or PIN).
98