Advertisement
The heaters can be reconnected to 230V3~
according to fig. 4.
The connection should be made with a cable
type S05VV-U, A05VV-R or similar. For con-
trol H05VV5-F0,75 mm² or similar may be
used.
Type
Output
Voltage
[kW]
[V]
All
control
230V~
SE 06
6
400V 3N~/230V 3~
SE 09
9
400V 3N~/230V 3~
SE 12
12
400V 3N~/230V 3~
SE 15
15
400V 3N~/230V 3~
SE 135
13,5
500V 3~/440V 3~
On the back of the appliance there are knock-
outs. Cable-glands used must guarantee the
protection class requirements!
When several heaters are connected to each
other and controlled by a common accessory
it should be stated in the group centre that
"The fan heaters are fed from more than one
group supply".
Start-up (E)
When the unit is used for the first time or
after a long period of disuse, smoke or odour
may result from dust or dirt that has collected
on the element. This is completely normal
and disappears after a short time.
Overheating
If the temperature limiter has been triggered
due to overheating, reset as follows:
• Disconnect the electricity with the all-pole
switch.
• Investigate the matter and repair the fault.
• Reset by opening the lid and pushing the
red button on top of the temperature limi-
ter until a click sound is heard.
• Put on the lid and reconnect the heater.
Maintenance
The motor and other components are mainte-
nance-free. Dust and dirt may cause overhea-
ting and danger of fire. The appliance must
therefore be cleaned regularly.
Panther 6/15
Residual current circuit breaker (E)
When the installation is protected by means
of a residual current circuit breaker, which
trips when the appliance is connected, this
may be due to moisture in the heating ele-
ment. When an appliance containing a heater
element has not been used for a long period
Min.area
or stored in a damp environment, moisture
[mm
]
2
can enter the element.
0,75
This should not be seen as a fault, but is
1,5/2,5
simply rectified by connecting the appliance
2,5/6
4/10
to the mains supply via a socket without a
6/16
safety cut-out, so that the moisture can be
4/2,5
eliminated from the element. The drying time
can vary from a few hours to a few days. As
a preventive measure, the unit should occa-
sionally be run for a short time when it is not
being used for extended periods of time.
Safety
• For all installations of electrically heated
• Ensure that the area around the intake and
• The appliance has hot surfaces during
• The appliance must not be covered either
• This appliance is not intended for use by
products should a residual current circuit
breaker 300 mA for fire protection be used.
exhaust grille is kept free from material
which could prevent the air flow through
the appliance.
operation!
with clothes or similar material since
overheating of the appliance can result in a
fire hazard.
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
GB
11
Advertisement
