Yamaha P-200 Service Manual page 9

16 Keyboard Assembly
16-1 Open the control panel unit. (see procedure 1)
16-2 Remove the nine (9) screws marked [200] and
two (2) screws marked [210]. The keyboard
assembly can then be removed. (Fig. 3)
* When taking the keyboard assembly out of the
main unit, slide it backward and hold it in the
middle. Lift the keyboard assembly from the
front and take it out of the main unit as shown
in the figures. (Fig. 6 and Fig. 7)
* Do not hold the keyboard by the ends.
Keyboard assembly
17 Disassembling the Keyboard
* After inserting a round stick (Rod:TX000670)
between the frame and keys, remove the
circuit boards. (Fig. 8)
17-A Take the keyboard assembly out of the main
unit. (see procedure 16)
17-B Remove the GH-D SW (L) circuit board by
removing the seven (7) screws marked [260A].
(Fig. 9)
17-C Remove the GH-D SW (H) circuit board by
removing the ten (10) screws marked [260B].
(Fig. 9)
* Keys can be removed without removing the
circuit boards.
* After removing the GH-D SW (L) and GH-D
SW (H) circuit boards, and the rubbers can
then be removed.
(Fig. 6)
Keyboard assembly
(Fig. 7)
P-200
9