Advertisement
Quick Links
I N S T A L L A T I O N & O P E R A T I O N G U I D E
HPS-4/HPS-6
HPS-4/HPS-6
HIGH POWER SPEAKER SELECTION SYSTEM
Niles Audio
Corporation
©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and
Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our products,
www.nilesaudio.com
Niles reserves the right to change product specifications without notice. The technical and other information
contained herein is not intended to set forth all technical and other specifications of Niles products. Additional
12331 S.W. 130 Street
information can be obtained on-line at www.nilesaudio.com or by calling Niles at 1-800-289-4434. Printed in
China 1/04 DS00358ACN
Miami, Florida 33186
Tel: (305) 238-4373
B
H
F
A
®
Fax: (305) 238-0185
L E N D I N G
I G H
I D E L I T Y
A N D
R C H I T E C T U R E
Advertisement
Related Manuals for Niles HPS-4/HPS-6
Summary of Contents for Niles HPS-4/HPS-6
- Page 1 HIGH POWER SPEAKER SELECTION SYSTEM Niles Audio Corporation ©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our products, www.nilesaudio.com Niles reserves the right to change product specifications without notice.
-
Page 2: Specifications
I G H W E R P E A K E R E L E C T I O N HPS-4/ HPS-6 High Power Speaker Selector System Introduction TABLE OF CONTENTS The HPS series allows you to connect multiple pairs of speak- Introduction ers to your stereo receiver or amplifier and play any one pair, any combination of pairs, or all pairs at once. - Page 3 If you have four pairs of 8-ohm speakers playing, the HPS-4/HPS-6 series will present a 4.5 ohm impedance load to Y S T E M I G H 3.
-
Page 4: Installation
Using the HPS Series with Tube-Type Amplifiers Virtually all tube amplifiers must have a load connected at all times. If the amplifier to be connected to the HPS-4/HPS-6 is a tube amplifier, be sure to always have at least one pair of speak- ers switched on at all times. - Page 5 O W E R P E A K E R E L E C T I O N Tube Amplifier Niles HPS-4 Niles Audio Corporation Miami, Florida USA Niles Audio Corporation Miami, Florida USA AMPLIFIER AMPLIFIER SPEAKER 4 SPEAKER 4...
-
Page 6: Operation
Y S T E M Operation There are two ways to use the HPS-4/HPS-6. You may play one pair of speakers at a time, or play multiple pairs simultaneously. If you intend to play more than one pair of speakers at the same time, you will need to become familiar with the opera- tion of the PROTECTION button. - Page 7 1. Make sure the amplifier or receiver power is OFF and set the volume to minimum. “TECH TIP” 2. On the right side of the HPS-4/HPS-6’s front panel is a but- If your amplifier ton labeled PROTECTION. This button activates the or receiver has “A”...
-
Page 8: Features And Benefits
Refer to the protection chart for the correct setting of the Protection button. Constant Protection Switch The HPS-4/HPS-6 is equipped with a manual override for the protection circuit that enables you to defeat the front panel protection switch and maintain constant impedance protec- tion.