FWD/DND Setting by Fixed FWD/DND button
Pressing the fixed FWD/DND button in idle status allows the extension user to set the following items for
FWD/DND:
•
FWD/DND for trunk calls
The FWD/DND status for trunk calls to that extension can be switched temporarily without clearing
the FWD destination. During setting, the LED of the button shows the current trunk call FWD/DND
status. The forwarding type and destination for trunk calls can also be set.
•
FWD/DND for intercom calls
The FWD/DND status for intercom calls to that extension can be switched temporarily without
clearing the FWD destination. During setting, the LED of the button shows the current intercom call
FWD/DND status. The forwarding type and destination for intercom calls can also be set.
•
FWD—No Answer timer
The length of time until unanswered calls are forwarded can be modified. This setting is applied to
both intercom and trunk call forwarding.
•
FWD for Virtual PS
If the extension is the first registered extension in an Incoming Call Distribution Group, the
extension user can set the FWD destination and forwarding status (on/off) for up to 4 virtual PSs
preregistered to the group. (→ 1.25.6 Virtual PS)
These settings are only available when FWD/DND buttons are set through system programming to FWD/
DND Setting mode.
Conditions
•
When FWD/DND buttons are set to FWD/DND Cycle Switch mode, pressing the FWD/DND button
cycles the FWD/DND setting.
In this mode, when intercom calls are set to be handled differently from trunk calls (forwarding type,
forward destination, DND on/off):
a)
in idle mode, the light patterns of the FWD/DND—Both button (including FWD/DND button [fixed
button]) and the Group FWD—Both button will indicate the setting for either trunk calls or intercom
calls, but not both.
b)
the FWD and DND icons on a PS display reflect the settings for trunk calls only.
c)
pressing the FWD/DND—Both button (including FWD/DND button [fixed button]) or the Group
FWD—Both button will be ignored.
•
When both the FWD and DND features are assigned simultaneously, pressing the button changes the
settings as follows:
FWD
•
A FWD/DND button customised on a flexible button is always in FWD/DND Cycle Switch mode, and the
mode cannot be changed.
Programming Manual References
PC Programming Manual
2.8.8 [2-6-1] Numbering Plan—Main—Features
→ FWD/DND Set / Cancel: Call from CO & Extension
→ FWD/DND Set / Cancel: Call from CO
→ FWD/DND Set / Cancel: Call from Extension
→ Group FWD Set / Cancel: Call from CO & Extension
→ Group FWD Set / Cancel: Call from CO
DND
Off
1.3 Call Forwarding (FWD)/Do Not Disturb (DND) Features
Feature Guide
77