Panasonic KX-TDA30 Features Manual page 372

Hide thumbs Also See for KX-TDA30:
Table of Contents

Advertisement

1.30 Networking Features
3.
QSIG Port Setting [Monitored PBX]
ISDN-QSIG (PBX Direct Connection)
Each QSIG port of a BRI or PRI card that will be used to transmit extension status information must be
set to do so through system programming. Even if a port is set to not transmit information, it will still
receive information from other PBXs.
→ 2.7.14 [1-1] Slot—BRI Port—ISDN CO—Networking Data Transfer
→ 2.7.16 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking
Data Transfer
Transmit
Enabled
Disabled
Set the transmission setting for each port according to the layout of your network, so that extension
status information can travel between NDSS monitor PBXs.
[Example ISDN Network Port Setting]
4001 NDSS
Idle
Busy
IP-GW-QSIG
IP data is routed through the network according to the routing tables of the IP-GW cards. When using
VoIP, it is necessary to identify the monitor PBXs, to which to transmit extension status information, for
each card that will be used. This is done by specifying the extension number of any extension (for
example, the PBX operator) at the monitor PBX as a Network Operator extension for that IP-GW card.
372
Feature Guide
Extension Status Information Functions
Transmit information on own PBX extensions
Receive information from other PBXs; forward it to other QSIG ports of the
PBX
Re-transmit information received by other QSIG ports of the PBX
Receive information from other PBXs; forward it to other QSIG ports of the
PBX
PBX-1
OFF
Network ID 1
ON
4001
Busy
ON
PBX-3
OFF
4001
Busy
ON
4001
Busy
PBX-5
PBX-2
OFF
Network ID 0
OFF
OFF
PBX-4
ON
Network ID 3
4001
Idle
Busy

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tda100Kx-tda200Kx-tda600Kx-tde100Kx-tde200

Table of Contents