Panasonic KX-TDA30 Features Manual page 317

All other operations, including pressing other Room Status Control buttons, will be ignored. In addition, the
lights of fixed and flexible buttons do not show their normal display pattern. In order to perform other
operations, the hotel operator must exit Room Status Control mode.
Conditions
• An EMEC or MEC card must be installed to use guest billing functions.
• A maximum of four hotel operators can be assigned.
• Only one of each type of Room Status Control button can be assigned.
• Extensions associated with rooms must be one of the following types:
PT (including IP-PT), SLT, ISDN Extension, T1-OPX
PSs cannot be checked in and out as room extensions.
• It is recommended that the extension number of a room extension is the same or similar to the room
number, for convenience.
• The previous guest's billing data is only cleared when an extension is set back to Check-in status. Thus,
it is possible to edit guest charge data and reprint the bill at any time until another guest is checked in
to the same room.
• If enabled through system programming, the check-in and check-out information is recorded on SMDR.
Installation Manual References
KX-TDA30
2.5.7 MEC Card (KX-TDA3105)
KX-TDA100/KX-TDA200
2.3.2 MEC Card (KX-TDA0105)
KX-TDA600
2.3.2 EMEC Card (KX-TDA6105)
Programming Manual References
PC Programming Manual
2.10.5 [4-1-4] Wired Extension—Flexible Button—Type
2.10.17 [4-3] DSS Console—Flexible Button—Type
2.12.9 [6-8] Hotel & Charge
→ Main—Hotel Operator—Extension 1–4
→ Bill—Checkout Billing—Billing for Guest (Need MEC Card)
PT Programming Manual
None
Feature Guide References
1.6.1.4 Last Number Redial
1.9.3 Extension Dial Lock
1.26.1 Station Message Detail Recording (SMDR)
1.28.4 Timed Reminder
1.27 Hospitality Features
Feature Guide 317