7. Install the optical drive retainer on the side of the new optical drive.
Figure 29. Installing the optical drive retainer
8. Slide the new optical drive into the drive bay from the front of the computer until the optical drive
snaps into position.
Figure 30. Installing the optical drive
9. Connect the signal cable and the power cable to the new optical drive.
10. Install the front bezel. See "Replacing the front bezel" on page 52.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 74.
Replacing the power supply assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
.
Chapter 7
Installing or replacing hardware
63