Grip Rubber - Hitachi NV 83A2 Technical Data And Service Manual

(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Before reassembly, remove dust from the groove of the Nail Guide [95].
Fit the convex portions of Sub Nail Stopper [92] and Feeder Set [35] in the Sub Stopper Spring [93] and
Main Stopper Spring [103] securely. Be careful not to mistake Sub Stopper Spring [93] for Main Stopper
Spring [103].
After reassembly, push Sub Nail Stopper [92] and Feeder Set [35] with fingers to check that they
smoothly return to position.
Mount the Nail Guide Shaft [101] facing its chamfered side upward.
Bend the tip of the Cover [105] and engage it with the convex portion of Magazine [81]. (See Fig. 15.)

10.6 Grip Rubber

The Model NV 83A2 is equipped with the grip-rubber handle that is common to the Model NR 83AA2. However,
the grip rubber is not supplied as a spare part because it is difficult to detach/attach the grip rubber. If
replacement of the grip rubber is required, replace the Body (B) [27] or attach the grip tape.
How to attach the grip tape and the fixing tape
Grip tape (A): Code No. 881768
Fixing tape: Code No. 880407
Grip tape (A) and the fixing tape are adhesive-backed. Start wrapping grip tape (A) near the roll pin hole of the
body and wrap around body completely. After wrapping, fix grip tape (A) with the fixing tape at both ends of
wrapping (Fig. 20). Note that grip tape (A) and fixing tape cannot be removed once they are adhered.
Fixing tape
Wrapping amount: 1.5 mm to 3 mm
End of grip tape (A)
Fig. 20
--- 36 ---
Body
End of grip tape (A)
Grip tape (A)