Installing The Power Connector Port; Removing The System Board - Dell Latitude 3570 Owner's Manual

b. base cover
c. hard drive assembly
d. keyboard
e. palmrest
f. display cable
3. To remove the power connector port:
a. Disconnect the power connector port cable from the connector on the system board [1].
b. Release the power connector port cable from the placeholders.
c. Remove the screw that secures that power connector port to the computer [2].
d. Lift and remove the power connector port from the computer [3].

Installing the power connector port

1. Insert the power connector port into the slot on the computer.
2. Route the power connector port cable through the routing channels.
3. Connect the power connector port cable to the connector on the system board.
4. Tighten the screw to secure the power connector port to the computer.
5. Install the:
a. display cable
b. palmrest
c. keyboard
d. hard drive assembly
e. base cover
f. battery
6. Follow the procedure in

Removing the system board

1. Follow the procedure in
2. Remove the:
a. battery
b. base cover
c. hard drive assembly
d. WLAN card
20
After Working Inside Your
Before Working Inside Your
computer.
Computer.