Canon MG6400 SERIES Online Manual page 244

Note
• Enter the same SSID that the access point is configured to use. The SSID is case-sensitive.
Encryption Method:
Select the encryption method used over the wireless LAN.
You can change WEP settings with selecting Use WEP and clicking Configuration....
Changing the WEP Detailed Settings
You can change WPA or WPA2 settings with selecting Use WPA or Use WPA2 and clicking
Configuration....
Changing the WPA or WPA2 Detailed Settings
Important
• If all encryption types of the access point, printer, or computer do not match, the printer cannot
communicate with the computer. If the printer cannot communicate with the computer after the
encryption type of the printer was switched, make sure that encryption types for the computer and the
access point matches that set to the printer.
• If you connect to a network that is not protected with security measures, there is a risk of disclosing
data such as your personal information to a third party.
TCP/IP Setup:
Sets the IP address of the printer to be used over the LAN. Set a value appropriate for your network
environment.
6. Click OK.
After changing configuration, a screen is displayed asking you for confirmation before the settings are
sent to the printer. If you click Yes, the settings are sent to the printer and the Transmitted Settings
screen is displayed.
Note
• Changing the network settings with the USB cable temporarily may switch the default printer. In this
case, reset Set as Default Printer.
244