Download  Print this page

Procedure For Measurement Of Microwave Energy Leakage; Check For Microwave Leakage; Note On Measurement; Leakage Measuring Procedure - Samsung MW7490W Service Manual

Hide thumbs

Advertisement

Table of Contents
Alignment and Adjustments

5-9 Procedure for Measurement of Microwave Energy Leakage

1) Pour 275±15cc of 20±5˚C(68±9˚F) water in a beaker which
is graduated to 600cc, and place the beaker in the center of
the oven.
2) Start to operate the oven and measure the leakage by using
a microwave energy survey meter.
3) Set survey meter with dual ranges to 2,450MHz.
4) When measuring the leakage, always use the 2 inch spacer
cone with the probe. Hold the probe perpendicular to the
cabinet door. Place the spacer cone of the probe on the
door and/or cabinet door seam and move along the seam,
the door viewing window and the exhaust openings
moving the probe in a clockwise direction at a rate of 1
inch/sec. If the leakage testing of the cabinet door seam is taken near a corner of the door, keep the probe
perpendicular to the areas making sure that the probe end at the base of the cone does not get closer than
5cm to any metal. If it gets closer than 5cm, erroneous readings may result.
5) Measured leakage must be less than 4mW/cm
Maximum allowable leakage is 5mW/cm
4mW/cm
is used to allow for measurement and meter accuracy
2

5-10 Check for Microwave Leakage

1. Remove the outer panel.
2. Pour 275±15cc of 20±5˚C(68±9˚F) water in a beaker which
is graduated to 600cc, and place the beaker in the center of
the oven.
3. Start the oven at the highest power level.
4. Set survey meter dual ranges to 2,450MHz.
5. Using the survey meter and spacer cone as described
above, measure arnear the opening of magnetron, the
surface of the air guide and the surface of the wave guide
as shown in the following photo.( but avoid the high
voltage components.) The neading should be less than
4mW/cm2.

5-11 Note on Measurement

1) Do not exceed the limited scale.
2) The test probe must be held on the grip of the handle, otherwise a false reading may result when the
operator's hand is between the handle and the probe.
3) When high leakage is suspected, do not move the probe horizontally along the oven surface; this may
cause damage to the probe.
4) Follow the recommendation of the manufacturer of the microwave energy survey meter.

5-12 Leakage Measuring Procedure

5-12-1 Record keeping and notification after measurement
1) After adjustment and repair of a radiarion preventing device, make a repair record for the measured
values, and keep the data.
2) If the radiation leakage is more than 5 mW/cm
functioning properly and the identical parts are replaced as listed in this manual notift that fact to ;
CENTRAL SERVICE CENTER
5-12-2 At least once a year have the microwave energy survey meter checked for accuracy by its manufacturer.
5-4
2
, after repair or adjustment.
.
2
2
after determining that all parts are in good condition,
Samsung Electronics

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Samsung MW7490W