Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for NHT SW10
Summary of Contents for NHT SW10
- Page 1 U s e r ’ s M a n u a l M o d e l SW12 SW10 P o w e r e d S u b w o o f e r...
-
Page 2: Important Safety Instructions
18. SERVICING - Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. For service warranty information call the NHT Hotline number: 1-800-NHT-9993. - Page 3 To properly set volume: • Turn down the volume control on the SW10 ll or SW12 to its lowest position (counter-clockwise). • Turn on your audio system, including the SW10 ll or SW12.
- Page 4 When a signal is received, it immediately turns on again. As AUTOMode is automatic, it requires no adjustment, nor is there a need to turn the SW10 ll or SW12 on and off every time it is used. When in ON Mode, the sub-...
- Page 5 Out is an unbuffered pass through used for multiple subwoofers. (9) Hi Level Input - Speaker level input connector. (10) Power Switch - Turns the unit on and off (11) Fuse Holder - location of the user servicable fuse...
- Page 6 L & R speakers. If you find that your receiver will not accommodate more than one cable per output terminal, Main Speakers check with your NHT dealer for alternative methods of connection. SW10 / SW12 Back of Subwoofer...
-
Page 7: Frequency Chart
Listen to your system and make adjustments to achieve a seamless blend between your main speakers and the SW10 ll or SW12. Four common prob- lems are outlined below. Follow the flow chart to correct these. See the glossary for any terms you are unfamiliar with. -
Page 8: Operation
For systems operating at 230 volts, use only a 5x20 mm, T2.5A, 250-volt slow-blow fuse. Troubleshooting If the SW10 ll or SW12 fails to operate at all when the Power Switch is turned on, thoroughly check the power cord, input and output connections... - Page 9 Satellite: Front L & R speakers when used with a sub- woofer. Also referred to as "main speakers". Sensitivity: A ratio of voltage across the speaker load to the acoustic power output, measured in decibels. Sub Out: An line level output for connection to a sub- woofer or subwoofer signal processor.
- Page 10 NHT dealer, Now Hear This (NHT) warrants that if it fails to function properly due to a manufacturing defect, despite its being installed and operated accord- ing to these instructions and used under normal conditions, it will be either replaced or repaired with new or rebuilt parts (both at NHT's option) with a unit of comparable value without charge to you.