Download Print this page

NHT ST4 User Manual

Nht tower loudspeaker user's manual st4

Hide thumbs Also See for ST4:

Download this manual

U s e r ' s

M a n u a l

ST4

M o d e l

T o w e r

L o u d s p e a k e r

Page 1 U s e r ’ s M a n u a l M o d e l T o w e r L o u d s p e a k e r...
Page 2 ST4 a good investment, and invite your comments. If you find your experience with the ST4 as satisfying as we believe you will, and wish to enjoy its high quality sound through your entire system, you'll find information about other sonically matched NHT Super Series loudspeakers on the back of this manual.
Page 3 Min. 150 Watts Made in China Adjust the spikes as needed to ensure that the ST4 is level and does not rock in any direction, then tighten the lock nuts against the bottom of the stabilizer bars to lock the spikes in place.
Page 4 Bi-amplification On the back panel of the ST4 you'll find two sets of binding posts (fig. 4) and a metal jumper strap connecting them. connect the ST4's to your system, namely, bi-amplifying.
Page 5 After doing so, connect one amplifier's output speaker wires to the top set of ST4 binding posts and one set to the bottom set, hand-tighten the posts, and as in standard mode, separate the speaker cables from others.
Page 6: Limited Warranty
(both at NHT's option) with a unit of comparable value without charge to you.
Page 7: Driver Complement
Polypropylene (Not Video Shielded) 31Hz - 180Hz 78Hz - 22kHz +/- 3dB +/- 3dB Speaker level and line level high pass 100Hz 2.3 KHz Continuously variable low pass: 40Hz -180Hz 86dB / 2.83v 8 ohm nominal 15 watts 15 watts...