Care And Cleaning; Cleaning The Appliance; Do Not Use These Cleaners; Rectifying Faults - Siemens ET475MY11E Instruction Manual

Care and cleaning

In this chapter you will find tips on how to maintain and clean
your appliance correctly.
:
Risk of electric shock!
Do not use high pressure washers or steam cleaners to clean
the appliance.
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of burns!
When you add water or ice cubes to the hot grilling surface, it
will spit and steam will form. Do not bend over the appliance.
Keep a safe distance away.

Cleaning the appliance

Clean the appliance after each use, once it has cooled down.
Burnt on residue is difficult to remove.
Remove rough residue with the spatula.
Ice cubes are better suited to cleaning the warm appliance than
water as they create fewer splashes and less steam.
Remove residue of cleaning agent carefully before the next use.
Cleaning the warm appliance
Switch off the appliance. Leave to cool down for at least
1.
15 minutes!
Place ice cubes or water on the grilling surface. Add a few
2.
squirts of washing-up liquid. Leave the dirt to soak.
Only begin cleaning once the residual heat indicator has
3.
switched from to .
• œ
Cleaning the appliance when cold
Place some water and washing-up liquid on the grilling
1.
surface until it is just covered.
Switch on the appliance.Set cleaning level
2.
to soak (max. 1 hour).
After dissolving the dirt, you can begin cleaning.
3.
Intermediate cleaning between two grilling processes
Switch off the appliance.
1.
Push 4 - 5 ice cubes over the hot grilling surface using the
2.
spatula.

Rectifying faults

Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
Display Fault
Blank There is no power supply.
The control panel is damp or an object
is flashing
"
is resting on it.
Appliance fault
+ number
"§
/ /
"‹ "‡ "ˆ
The electronics have overheated and
"...
have switched off the appliance.
The appliance was in operation for too
"‰
long and has switched itself off.
Remove dissolved dirt with the spatula.
3.
Switch the appliance on again.Do not add food until the
4.
appliance has reached the set temperature again.
Appliance part/
surface
Grilling surface
Grilling surface,
burnt-on dirt
Stainless steel
frame
Control panel

Do not use these cleaners

Scouring or chemically aggressive cleaners
■
Don't allow acidic cleaners (e.g. vinegar, citric acid, etc.) to
■
. Leave the dirt
,
get on the frame or panel.
Cleaners containing chlorine or with a high content of alcohol
■
Oven cleaner
■
Hard and scratchy sponges, brushes or scouring pads
■
Thoroughly wash out new sponge cloths before using them.
■
Measure
Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
Dry the control panel or remove the object.Then touch any control.
Switch the appliance off and on again. Contact the after-sales service if
this appears in the display again.
Wait until the electronics have cooled down sufficiently. Then touch any
control.
You can switch the appliance back on again immediately.
Recommended cleaning
Remove fatty residues with washing-up
liquid.
Depending on the type of food, white
flecks may remain on the grilling sur-
face. Remove with lemon juice or vine-
gar. Then wipe thoroughly with a damp
cloth. Lemon juice or vinegar must not
come into contact with the control
panel.
Brush stubborn dirt on the cold appli-
ance with our grill cleaner gel (order
no. 463582) and leave to act for at
least 2 hours, or overnight in severe
cases. Then rinse thoroughly and dry.
Note the packaging instructions of the
cleaner.
Clean with a soft, damp cloth and
some washing-up liquid.
Use our stainless steel cleaner (order
no. 464524) for stubborn dirt. This will
give matt stainless steel shine again.
Clean with a soft, damp cloth and
some washing-up liquid; the cloth
should not be too wet. Dry off with a
soft cloth.
17