10
. CRANKCASE/CRANKSHAFT
Remove the remaining bearing on the
crankshaft side using the universal bearing
puller.
*
When separating the crankcase, the oil
seals must be removed. Replace the
oil seals with new ones.
CRANKSHAFT INSPECTION
Measure the connecting rod big end side
clearance.
Service Limit: 0.6mm replace if over
Measure the connecting rod big end radial
clearance at two points in the X and Y
directions.
Service Limit: 0.04mm replace if over
SUPER8 50 2T
Universal Bearing Puller
10-4