Tilt Support Lever For Power Trim And Tilt Model; Top Cowling Release Lever - Yamaha 115C Owner's Manual

Components
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
1. Tilt support lever
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
EMU26401

Top cowling release lever

The top cowling can be removed by operat-
ing the cowling release lever. Pulling the
front lever unlocks the top cowling for remov-
al.
18
1
When installing the top cowling:
1.
2.
ZMU03979
3.
4.
ECM00070
NOTICE
Make sure the cowling lock connection
G
cable is operating correctly before rein-
stalling the top cowling.
When the release lever is operated,
G
both the front and rear cowling hooks
should be released at the same time. If
not, adjust the rear clamp cable adjust-
Set the top cowling straight down onto
the engine, being careful to avoid catch-
ing spark plug wires or other wires.
Align the three cowling hooks with the
locks on the bottom cowling.
Press down on the top of the cowling at
the front and both sides of the back until
the three locks click.
To make sure the cowling is locked
properly push the cowling from each
side. If it lifts, repeat step 3.
ZMU03518
ZMU03519