Troubleshooting - Bosch AHS 35-15 LI Original Instructions Manual

OBJ_BUCH-1685-001.book Page 17 Friday, September 21, 2012 9:44 AM

Troubleshooting

Problem Possible Cause
Hedgecutter does not op- Battery discharged
erate
Safety switch not activated correctly
Hedgecutter operates in- Internal wiring of garden product damaged
termittently
On/Off switch defective
Motor reverses repeatedly then stalls after 3 s. see "Working Advice" (Anti Blocking)
Motor runs but blades re- Internal fault
main stationary
Cutting blade hot Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Blade will not move Battery discharged
Garden product defective
Excessive vibra- Garden product defective
tions/noise
Cutting time per battery Too much friction, due to lack of lubricant
charge too low
Blade needs cleaning
Battery not fully charged
Continuous lighting of the Battery not (properly) inserted
battery charge indicator
Battery contacts contaminated
No charging procedure
possible
Battery defective
The blades are running Battery discharged
slow or the anti blocking
Battery stored outside of battery temperature
feature is not functioning
Battery charge indicator Mains plug of battery charger not plugged in
does not light up (properly)
Socket outlet, mains cable or battery charger
defective
Bosch Power Tools
English | 17
Corrective Action
Recharge battery; also see "Battery Charging"
see "Mounting and Operation" for correct use
Contact Service Agent
Contact Service Agent
Contact Service Agent
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact Service Agent
Apply lubricant spray
Clean blade
Recharge battery; also see "Battery Charging"
Properly insert battery into battery charger
Clean the battery contacts (e.g. by inserting
and removing the battery several times) or re-
place the battery
Replace the battery
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room tem-
perature (within battery operating temperature
0–45 °C)
Insert mains plug (fully) into the socket outlet
Check the mains voltage; have the battery
charger checked by an authorised after-sales
service agent for Bosch power tools
F 016 L70 876 | (21.9.12)