Installation - Ei Electronics Ei207/208 Series Instructions Manual

4. Installation

Warning: The Installations of this apparatus should not be used for a subsitute
for proper installation, use and maintenance of fuel buring appliances including
appropriate ventilation and exhaust systems.
4.1 Installation Procedure
1. Select a location complying with the advice in
'Where to place CO Alarms' section.
2. Remove the mounting plate from the packaging/
Alarm.
3. Place the mounting plate on the ceiling/wall
exactly where you want to mount the Alarm. With
a pencil, mark the location of the two screw holes.
4. Taking care to avoid any electrical wiring in the
ceiling, drill holes using a 5.0mm drill bit through
the centre of the marked locations. Push the plastic
screw anchors provided into the drilled holes. Screw
the mounting plate to the ceiling/wall.
Figure 4
5. Alternatively, if desired, the CO Alarm will also
free stand on a flat surface with the mounting plate
attached.
6. If using the RadioLINK interconnection, ensure the RF module is fitted correctly into
the base of the Alarm. For further advice on the RadioLINK installation, see booklet
"RadioLINK Module for Battery Powered Carbon Monoxide Alarms".
14