Download  Print this page

Initial Charge; Precautions - Kawasaki vn 800 classic Service Manual

1996-2006.
Hide thumbs

Advertisement

16-38 ELECTRICAL SYSTEM
Battery
Make sure air bubbles [A] are coming up from all six filler
ports.
Leave the container this way for 5 minutes or longer.
If no air bubbles are coming up from a filler port, tap [B]
the bottom of the container two or three times. Never
remove the container from the battery.
Fill the electrolyte into battery until the container is
completely emptied.
Be certain that all the electrolyte has flowed out.
Tap the bottom the same way as above if there is any
electrolyte left in the container.
Now pull the container gently out of the battery.
Let the battery sit for 20 minutes. During this time, the
electrolyte permeates the special separators and the gas
generated by chemical reaction is released.
Fit the seal caps [A] tightly into the filler ports until the seal
cap is at the same level as the top of the battery.
Do not hammer. Press down evenly with both hands.
Once you install the seal caps after filling the bat-
tery, never remove it, nor add any water or elec-
trolyte.

Initial Charge

While a sealed battery can be used after only filling with electrolyte, a battery may not be able to
sufficiently move a starter motor to start an engine in the cases shown in the table below, where an
initial charge is required before use. However, if a battery shows a terminal voltage of higher than
12.8 V after 10 minutes of filling (Note 1), no initial charge is necessary.
Condition requiring initial charge
At low temperatures (lower than 0°C)
Battery has been stored in high temperature and humidity.
Seal has been removed, or broken-peeling, tear or hole.
Battery as old as 2 years or more after manufacture.
Battery manufacturing date is printed on battery top.
Example)
12
Day
Note 1: Terminal voltage-To measure battery terminal voltage, use a digital voltmeter.

Precautions

1) No need of topping-up
No topping-up is necessary in this battery until it ends its life under normal use. Forcibly prying off the
seal cap to add water is very dangerous. Never do that.
2) Refreshing charge
NOTE
CAUTION
NOTE
CAUTION
10
93
Month
Year
1.4 A × 2 ∼ 3 hours (VN800-B1 ∼ B8)
1.2 A × 2 ∼ 3 hours
1.4 A × 15 ∼ 20 hours
1.2 A × 15 ∼ 20 hours
T1
Mfg.
location
Charging method
(VN800-B1 ∼ B8)

Advertisement

Table of Contents

   Also See for Kawasaki vn 800 classic

This manual is also suitable for:

Vulcan 800 classic

Comments to this Manuals

Symbols: 0
Latest comments: