Operation; Maintenance - Makita 9032 Instruction Manual

OPERATION

Hold the tool firmly with both hands. Turn the tool on and
wait until it attains full speed. Gently apply the tool to the
workpiece surface and move the tool forward and back.
Press the belt only lightly on the workpiece. Excessive
pressure may damage the belt and shorten tool life.
Always use "A" range of the belt to sand the workpiece.
"A" range
001223
Fig.8
Fig.9
CAUTION:
Secure the workpiece with clamps, etc. if there is
•
any possibility of it moving during the work
operations.
The tool should not already be in contact with the
•
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish, damage to the
belt or loss of control of the tool may result.
When working with the tool, be very careful to
•
avoid any contact of the tool and belt with any part
of your body or anyone or anything near you.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Fig.10
Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.11
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
1. Flat shoe
1
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive belts
•
Hose 28
•
Arm (6,9,13mm)
•
Dust nozzle assembly
•
5
or attachments
Only use accessory or
are