Selecting an area
Selecting how you
watch your TV
Clock: Setting the
Voice and motion
control: Setting the
Voice and motion
Set the Universal
If You Want to Rerun Setup...
Menu → System → Setup
You should do Setup again at home although you did in shop.
If You Want to Turn the Store Demo Mode On or Off.
To set or unset Store Demo mode outside of Setup, press and release the Controller when the power is
on. The Function menu screen appears. Push the Controller to the left (to MENU (m)) and hold for more
than 5 seconds. The Store Demo mode is set. To cancel Store Demo, bring up the Function menu using
the Controller, push the Controller to the right (to Source (s)) and hold for more than 5 seconds.
If You Want to Reset This Feature...
Select System - Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0". If
you want to change the PIN number, use the Change PIN function. You should do Setup (Menu → System)
again at home although you did in shop.
If you forget the PIN code, press the remote control buttons in the following sequence in Standby
mode, which resets the PIN to "0-0-0-0":
Select the appropriate area by pressing the ▲ or ▼ button.
button to confirm your choice.
Select the appropriate option for your TV using your remote, and then
: Memorise all of the available channels using RF cable.
• Yes, I need to.
: Do not need Auto Tuning when connecting a TV
No, I don't need to.
to set-top-box. If you select this option, go to 7 - Clock.
Set the Date and Time.
You can also set the Date and Time by pressing the number buttons on
the remote control.
You can turn the Voice and motion control function on or off. Select Off
or On, and then select Next.
Select Close to finish.
The completed settings are displayed.
1. Turn on the
2. Select Yes to start the Universal Remote Setup.
For more detailed information about the Universal Remote Setup,
refer to "Setting up the Universal Remote Control" section in the
manual (page 11).
→ 8 → 2 → 4 →
English - 18
button on the bottom of the IR Blaster, and then