When To Replace The Exhaust Filter; How To Replace The Airclean Filter; Replacing The Active Airclean 50, Airclean Plus 50 And Hepa Airclean 50 Exhaust Filters; Replacing One Type Of Exhaust Filter With Another - Miele HS15 Operating Instructions Manual

en
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.

When to replace the exhaust filter

Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
09).
a AirClean
Replace this filter every time you start a
new packet of Miele dustbags. An
AirClean exhaust filter is supplied with
every packet of Miele dustbags.
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Replace if the display for the exhaust fil-
ter change indicator is completely filled
with red (dia. 14). This occurs after ap-
prox. 50 hours of operation which is
equivalent to about a year of average
use. The vacuum cleaner can still be
used. However, the suction power will
be reduced as will the effectiveness of
the filter if it is not replaced in good
time.

How to replace the AirClean filter

(dia. 35 + 36)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille until it clicks.
 Grasp the used AirClean filter by one
of the clean, unsoiled sections and
take it out.
50
 Replace it with a new AirClean filter.
If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA
AirClean 50, see "Maintenance - Re-
placing one type of exhaust filter with
another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 50,
AirClean Plus 50 and HEPA AirClean
50 exhaust filters (dia. 37 + 38)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
 Press the exhaust filter change indic-
ator (dia. 12).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 13).
If you wish to fit an AirClean filter,
see "Maintenance - Replacing one
type of exhaust filter with another".
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 09)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean