Securing The Tv To The Wall; Storage And Maintenance - Samsung 4 SERIES User Manual

Hide thumbs Also See for 4 SERIES:

User manual (421 pages)

E-manual (34 pages)

Quick start manual (6 pages)

Table Of Contents

Table of Contents

Available languages

Caution: Pulling, pushing, or climbing onto the TV may cause the TV to fall. In particular, ensure that your

children do not hang over or destabilize the TV; doing so may cause the TV to tip over, resulting in serious

injuries or death. Follow all safety precautions provided on the included Safety Flyer. For added stability, install

the anti-fall device for safety purposes, as follows.

To avoid the TV from falling

1. Put the screws into the clamps and firmly fasten them onto the

wall. Confirm that the screws have been firmly installed onto the

wall.

✎

You may need additional material such as an anchor

depending on the type of wall.

✎

Since the necessary clamps, screws, and string are not

supplied, please purchase these additionally.

2. Remove the screws from the centre back of the TV, put the

screws into the clamps, and then fasten the screws onto the TV

again.

✎

Screws may not be supplied with the product. In this case,

please purchase the screws of the following specifications.

✎

Screw Specifications

For a 32 ~ 40 inch TV: M6

3. Connect the clamps fixed onto the TV and the clamps fixed onto

the wall with a strong string and then tie the string tightly.

✎

NOTE

Install the TV near to the wall so that it does not fall backwards.

It is safe to connect the string so that the clamps fixed on the wall are equal to or lower than the clamps fixed on

the TV.

Untie the string before moving the TV.

4. Verify all connections are properly secured. Periodically check connections for any sign of fatigue for failure. If you have any

doubt about the security of your connections, contact a professional installer.

✎

If you remove the attached sticker on the TV screen, clean the residues and then watch TV.

Do not spray water or a cleaning agent directly onto the

product. Any liquid that goes into the product may cause a

failure, fire, or electric shock.