1 V/Pa. The microphone is phantom powered from tomgespeist (IEC 1938). Das BCM 104 wird von der 48 V, 3.2 mA (IEC 1938). The BCM 104 is addressed Vorderseite besprochen. Diese ist durch das Neu- from the front, marked with the Neumann logo.
For more information, please see section 3.3.) 3. Power Supply 3.1 Phantom Powering The BCM 104 is phantom powered at 48 V (P48, IEC 1938). With phantom powering the DC from the positive supply terminal is divided via two identical resistors,...
Beim BCM 104 ist Pin 2 die heiße Phase, und Pin 3 Pin 2 of the BCM 104 is the ”hot“ phase, and pin 3 muss für unsymmetrische Eingänge an Masse gelegt must be connected to earth for unbalanced inputs (see werden (siehe Abb.
94 dB SPL. 1 Pa Klirrfaktor des Mikrophonverstärkers bei einer Eingangsspannung, THD of microphone amplifier at an input voltage equivalent to the die der von der Kapsel beim entsprechenden Schalldruck abgege- capsule output at the specified SPL. benen Spannung entspricht.
Function Test After assembly, to check that the microphone is once again functioning properly, a short function test at nor- mal speaking volume should be carried out. 5.1 If Servicing is Required...
Replacement Headgrille BCK ... ni ... Best.-Nr. 08520 BCK ... ni ... Cat. No. 08520 Austauschkorb für das BCM 104. Der Korb wird mit Replacement Headgrille for the BCM 104. It comes 5 verschiedenfarbigen Markierungsringen geliefert. with 5 rings of different colors.
Page 8
WS 47 47 47 47 47 ... sw ... Best.-Nr. 06826 WS 47 47 47 ... blk ... Cat. No. 06826 47 47 Windschutz für D-01. Durchmesser ca. 120 mm. Windscreen for D-01. Diameter is approx. 120 mm. Dämpfung des Windgeräusches ca. 22 dB. Dämpfung Suppression of the wind noise approx.
Page 9
Irrtümer und technische Änderungen vorbehalten • Errors excepted, subject to changes Printed in Germany • Publ. 01/04 88332/A01...
Need help?
Do you have a question about the bcm 104 and is the answer not in the manual?
Questions and answers