Setting The Destination - Pioneer CB-A802 Service Manual

1

7.3 SETTING THE DESTINATION

QQ
3 7 63 1515 0
In conventional models, as many number of sub-microcomputer units as that of destinations were designed, because a port
A
set for each destination was provided with a sub-microcomputer unit. However, with this model, the sub-microcomputer unit is
common to all destinations.
The data on the destination were written to the EEPROM on the AJKB Assy on the production line. When the AJKB Assy (or
the EEPROM) is replaced for service, writing of data on the destination is also required.
Procedures for destination setting
If the AJKB Assy is replaced, as the data on destination is not available, "No Area Information!!!" flashes on the screen. Press
the ESC then SPEED – keys to enter Destination Setting mode.
B
C
Select a destination area with a numeric key. For example, if the 1 key is pressed, the display will be as shown below:
TE
L 13942296513
D
Press the ESC key to exit Destination Setting mode without setting a destination area.
Press the SEARCH key to determine the selected destination area, write the data to the EEPROM, and terminate Destination
Setting mode.
When Destination Setting mode is terminated, ID Setting mode is automatically entered if the CPRM ID is not set yet.
Note: When the destination was set once, other destination cannot modify.
E
www
F
106
1
http://www.xiaoyu163.com
2
x ao
y
. i
DVD-V8000
2
http://www.xiaoyu163.com
3
8
Q Q
3 6 7 1 3
u163
.
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9