Subscribe to Our Youtube Channel
Summary of Contents for Network Technologies ETH-4X1 / 2X1
- Page 1 NETWORK TECHNOLOGIES INCORPORATED ETH-4X1 / 2X1 (MANUAL ETHERNET SWITCH) INSTALLATION / USER GUIDE MAN023 Rev Date 6/28/2002 1275 Danner Dr Tel:330-562-7070 Aurora, OH 44202 Fax:330-562-1999 www.nti1.com...
-
Page 2: Table Of Contents
Warranty Information ... 9 Introduction The NTI ETH-4X1 / ETH-2X1Manual Ethernet Switch was designed to enable the connection of one of four DEVICEs to one NETWORK or one DEVICE to one of four separate NETWORKs using standard ethernet cable. The user can control the ETH-4X1 / ETH-2X1 manually to make a single connection active between one NETWORK and one DEVICE at a time. -
Page 3: Application Examples
Application Examples... -
Page 4: Materials
A location should be chosen for the ETH-4X1 such that the ethernet cable from each supported device will reach The ethernet cables must be run to the locations where the ETH-4X1 switch, COMMON, and the SELECTABLE(s) will be mounted. Be careful to route the cables away from any sources of magnetic fields or electrical interference that might reduce the quality of the signal (i.e. -
Page 5: Features And Functions
3. Select Switches- (1-4)- for manual control of "COMMON" and user selectable ports (1-4) 4. RS232- 9 pin DIN male (optional)- for computer control of "COMMON" and user selectable ports (1-4) 5. Status LEDs- for visual indication of switch connection between the "COMMON" and the user selectable ports (1-4) 6. -
Page 6: Installation
Installation 1. Position the ETH-4X1 Manual Ethernet Switch such that the ethernet cable from the COMMON , the AC adapter power cable, and the ethernet cables from the SELECTABLEs can reach the ETH-4X1 Manual Ethernet Switch. 2. Connect one end of an ethernet cable to the COMMON (See Fig.1.) cable to the "COMMON"... -
Page 7: Plug-In And Boot Up
Make sure the power connector is properly inserted. (See Fig. 3.) 2. Plug the AC adapter into a power outlet. The “Power” LED on the ETH-4X1 Manual Ethernet Switch should illuminate indicating that a proper power connection has been made. -
Page 8: Technical Specifications
Any terminal program can be used to control the switch, if that program supports the given parameters (example HyperTerminal in Windows, Norton Commander terminal in DOS). An available standard serial port is needed. Accepted commands: Keystroke All other characters will be ignored. -
Page 9: Troubleshooting
Troubleshooting Each and every piece of every product produced by Network Technologies Inc is 100% tested to exacting specifications. We make every effort to insure trouble-free installation and operation of our products. If problems are encountered while installing this product, please look over the troubleshooting chart below. If an answer is not found in the chart, check the FAQs (Frequently Asked Questions) at our website at NTI directly for help at 800-742-8324 (800-RGB-TECH) in US &... -
Page 10: Warranty Information
742-8324 (800-RGB-TECH) or (330) 562-7070. Changes The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the right to make changes in the product design without reservation and without notification to its users.
Need help?
Do you have a question about the ETH-4X1 / 2X1 and is the answer not in the manual?
Questions and answers