Default Settings - Siemens FDOOT241-9 Technical Manual

4.6

Default settings

Building Technologies
Fire Safety & Security Products
The default parameter set (parameter set 0) is set in all fire detectors when
delivered.
The following table shows the default parameter set of the various fire detectors.
Fire detector
FDOOT241-x in FDnet operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT241-9 in collective operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT241-8 in MS8 operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT221
FDO241
FDO221
FDT241
FDT221
Upon commissioning of the fire detection system, the optimum parameter set must
be selected based on the existing risk and the ambient conditions.
If the fire detectors are operated on the FDnet (addressed), the fire detectors are
automatically set to the basic setting for the country in question when the control
panel is started up for the first time. Individual adaptation is made using the
commissioning tool of the corresponding control panel.
If the fire detectors are operated in collective or MS8 operation, the detectors
operate with their default setting on first commissioning. In this operating mode,
individual adaptation of the detector behavior is performed using the detector
exchanger and tester FDUD292.
Project engineering
Default parameter set
High Compensation
A1R
Universal
ES <13 = Insensitive / ES ≥13 = High
Compensation
A1R
Universal
Sensitive
A1R
Universal
Standard
Robust
Standard
A1R
A1R
55
007004_k_en_--
16.04.2009