Key; To Use Your Handmixer; Before Plugging In - Kenwood HM430 Instructions Manual

Use your Kenwood 6-speed
handmixer for mixing, beating and
whipping cream, eggs, sauces and
many other mixtures. Heavier doughs
and other mixtures can be prepared
with the kneaders included with
selected models of the handmixer.

before plugging in

Make sure your electricity supply is
G
the same as the one shown on the
rear of your handmixer.
Important – UK only
The wires in the cord are coloured as
G
follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by
G
a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover is
lost then the plug must not be used
until a replacement can be obtained.
The correct fuse cover is identified by
colour and a replacement may be
obtained from your Kenwood
Authorised Repairer (see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended for
contact with food.
before using your handmixer
for the first time
Wash the parts (see 'cleaning').
G

key

speed switch and tool release
button
Turbo button
bowl
stand
kneaders
beaters
cord wrap
stand release button
mixer holding bracket
bracket recess
mixer cradle
beater/kneader drive gear
bowl drive gear

to use your handmixer

Unwrap the cord from the cord wrap
G
before use.
1 Fit the mixer to the stand by sliding
the handmixer into the cradle
ensuring the tabs at the front of the
cradle slide into the slots on the
underside of the Handmixer.
2 Fit the holding bracket
bracket recess
Handmixer and clip securely into
place.
3 Press the stand release button
and lift the handmixer up so that the
beaters or kneaders can be fitted.
Note: for safety, the mixer will
only operate with the beaters
or kneaders in position.
4 Insert the beaters or kneaders into
the mixer – turn until a positive click
is heard.
If using the mixer with the stand,
G
ensure the beater/kneader with the
drive gear is inserted so it aligns with
the drive gear on the stand
If using the mixer without the stand,
G
the beater/kneader with the small
metal collar must be inserted into the
socket marked with the graphic
5 Place the ingredients into the mixing
bowl and then place the bowl on to
the stand.
6 Lower the Handmixer down until the
stand release button
into place.
7 Plug in and push the speed control
forward.
3
–
into the
at the rear of the
.
clicks back
.