Tax Programming - Samsung ER-4915 Programming Manual

Tax Programming

Straight Percentage Tax Programming
When tax requirements may be met using a straight percentage, use the
following method to program a tax as a straight percentage.
Straight percentage tax programming requires a seven-digit entry
(labeled N1 - N7 below). This assigns the rate as well as a two digit
option code defining the tax as add-on, inclusive (VAT), and/or Cana-
dian GST type tax. The rate is designated as 1, 2, or 3 using the
appropriate shift key.
*Tax Rate 3 programming does not apply to registers programmed
for Food Stamp operations.
Percentage and status programming is determined as follows:
Enter the rate (digits N1 through N5), using the decimal key, leading
zeros are not required (6.000 = 6%, 10.500 10.5%, etc.). This is
followed by the status (two digits), then press TAX 1 SHIFT for tax 1,
TAX 2 SHIFT for tax 2, or TAX 3 SHIFT for tax 3. Percentage tax
programming for that rate is complete.
To arrive at a status value for N6 & N7 use the chart below. N7 must be
"0" for rates 1 & 2.
Carry the desired value for addresses with single options directly to the "SUM" column. For
addresses with multiple choices, enter values of individual options in "=" column, add, and
enter the combined value in the "SUM" column.
ADDRESS
Tax is Straight % / Add On
N6 Tax is Tax Table / Add On
Tax is Straight % / VAT
GST (Tax 3) is taxable by Rate 1
N7
GST (Tax 3) is taxable by Rate 2
6
.
N1 N2
< RATE
TAX PROGRAMMING OPTIONS
ER-4915 Dealer Pocket Programming Guide
N3 N4 N5 N6
>
TAX 1
SHIFT
N7
TAX 2
SHIFT
TAX 3
SHIFT *
VALUE
= 0
= 1
= 2
YES = 1
NO = 0
YES = 2
NO = 0
= SUM
(A)
(B) (A+B)