Yamaha 2006 RX10GTAXW Service Manual page 140

Diagnostic Mode Table
Switch the meter display from the regular mode to the diagnosis mode. To switch the display, refer to
"DIAGNOSTIC MODE".
NOTE:
• Check the intake air temperature and coolant temperature as close as possible to the intake air
temperature sensor and the coolant temperature sensor respectively.
• If it is not possible to check it with an atmospheric pressure gauge, judge it by using 101.3 kPa as
the standard.
• If it is not possible to check the intake air temperature, use the ambient temperature as reference.
Diagnostic
Item
Code
Throttle angle
01
Atmospheric pressure Displays the atmospheric pressure.
02
Intake air pressure
03
Intake temperature
05
Coolant temperature
06
Vehicle speed pulse
07
Fuel system voltage
09
(battery voltage)
Throttle switch
24
Grip warmer testing
26
Thumb warmer tesing Activate the grip warmer by depressing the rocker switch once
27
FUEL INJECTION SYSTEM
Description of Action
Displays the throttle angle.
• Check with throttle fully closed.
• Check with throttle fully open.
* Use an atmospheric pressure gauge to check the atmospheric
pressure.
Displays the intake air pressure.
Engine stop switch is on.
* Generate the pressure difference by cranking the engine with
the starter, without actually starting the engine.
Displays the intake air temperature.
* Check the temperature in the air cleaner case.
Displays the coolant temperature.
* Check the temperature of the coolant.
Displays the accumulation of the vehicle pulses that are
generated when the track is spun.
Displays the fuel system voltage (battery voltage).
Engine stop switch is on.
The meter displays the following items: During the throttle switch
ON (throttle open): ON
During the throttle switch OFF (throttle close): OFF
Activate the grip warmer by depressing the rocker switch once
to the "LOW" position. One second after activating the grip warmer,
the circuit will be energized and the grip warmer will start to heat
up. Note: The engine warning lamp is lit during this operation as
confirmation the circuit has been activated.
If you depress the grip warmer rocker switch before the second
has elapsed, you will reset the activation process and will have
wait another second before the grip warmer circuit is
energized.
.
to the "LOW" position. One second after activating the thumb
warmer circuit, the thumb warmer will be energized and will
start to heat up. Note: The engine warning lamp is lit during this
operation as confirmation the circuit has been activated.
If you depress the thumb warmer rocker switch before the
second has elapsed, you will reset the activation process and will
have wait another second before the thumb warmer circuit is
energized.
.
68
FI
Data Displayed on Meter
(reference value)
0 ~ 125 degrees
• Fully closed position (15 ~ 18)
• Fully open position (95 ~ 100)
Compare it to the value
displayed on the meter.
• Not cranking-atmospheric
pressure
• Cranking-intake air pressure It
changes at the value whitch is
smaller than in the
atomospheric pressure.
Compare it to the value
displayed on the meter.
(min–30 [°C])
Compare it to the value
displayed on the meter.
(min–30 [°C])
(0 ~ 999; resets to 0 after 999)
OK if the numbers appear on
the meter.
0 ~ 18.7 V
Normally, approximately 12.0 V
–
–
–