Isa/pci motherboard with onboard agp vga, pci audio, pci ide and super multi-i/o (9 pages)
Summary of Contents for EPOX kl-133m
Page 1
User’ User’ s s s s s User’ User’ User’ Manual Manual Manual Manual Manual An AMD Soc AMD Soc AMD Soc k k k k k et et et et et A Pr AMD Soc A Pr A Pr A Pr ocessor based ocessor based ocessor based...
Page 3
Table of Contents Page Section 1 Introduction Overview Section 2 Features Section 3 Installatio Easy Installation Procedure Section 4 Award BIOS Setup...
Page 22
Installation Note: Either Front Panel Audio or onboard rear audio could be used at one time. -Data +Data +Data -Data Page 3-10...
Page 23
Installation Device Connectors (continued) Power On/Off Turbo LED indicator - IDE LED indicator - IR Connector Power LED - Speaker - Reset - Page 3-11...
Page 24
Installation Section 3-5 External Modem Ring-in Power ON and Keyboard Power ON Functions (KBPO) Keyboard Power-ON Function JP4 = 1-2 Disabled (Default) = 2-3 Enabled ® ® Notes: Page 3-12...
Page 25
Installation 3-6 STR (Suspend To RAM) Function ® ® Page 3-13...
Page 26
Installation ACPI Onboards LED Status Indicator Table Status Onboards Shutdown Plug in the ATX Power ON Green Mode (Soft-OFF) Location Power Core J3(PW-ON) (S1) (S3) (S5) LED1 (Red LED) Blinking Blinking PW_LED Page 3-14...
BIOS NOTE: If the hard disk Primary Master/Slave and Secondary Master/ Slave are set to Auto, then the hard disk size and model will be auto-detected. NOTE: The Halt On: field is used to determine when to halt the system by the BIOS if an error occurs.
Page 30
BIOS Note: Many disk diagnostic programs that access the boot sector table can trigger the virus warning message. If you plan to run such a program, we recommend that you first disable the virus warning Page 4-4...
Page 31
BIOS Note: BIOS can not tell the difference between 720K, 1.2MB and 1.44MB drive types as they are all 80 tracks. Page 4-5...
BIOS 4-3 Advanced Chipset Features Figure 4: Chipset Features Setup Page 4-8...
Page 35
BIOS Enabled: This field enables the main memory (15~16MB) to remap to ISA BUS. Disabled: Normal Setting. Note: If this feature is enabled you will not be able to cache this memory segment. Page 4-9...
BIOS 4-4 Integrated Peripherals Figure 5: Integrated Peripherals Note: If you do not use the Onboard IDE connector, then you will need to set Onboard Primary PCI IDE: Disabled and Onboard Secondary PCI IDE: Disabled Note: The Onboard PCI IDE cable should be equal to or less than 18 inches (45 cm.).
BIOS 4-6 PNP/PCI Configuration WARNING: Conflicting IRQs may cause the system to not find certain devices. Figure 7: PCI Configuration Setup Page 4-19...
Drivers Installation Section 5 Driver Installation Easy Driver Installation Insert the bundled autorun driver CD-disk. Step 1 : To Click the Service Pack 4in1 Driver. Install all components recommended. Step 2 : To Click the VGA Driver for Win9x to install the VGA Driver. Step 3 : To Click the USB Driver to install the USB Driver.
Page 54
Drivers Installation Page Left Blank Page 5-2...
Page 55
Appendix Appendix A NOTE: The "LOAD Optimized DEFAULTS" function loads the system default data directly from ROM and initializes the associated hardware properly. This function will be necessary when you accept this mainboard, or the system CMOS data is corrupted. CMOS Setup Utility - Copyright ( C ) 1984-1998 Standard CMOS Feature Frequency/Voltage Control...
Need help?
Do you have a question about the kl-133m and is the answer not in the manual?
Questions and answers