Mitsubishi Electric WD-60C10 Service Manual page 39

MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-60638CA / WD-65638 / WD-65638CA /
WD-73638 / WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838
Phase 3 - 4:3 and 16:9 Alignment
1. With the Manual Geometry Alignment activated, press <VIDEO> to enter the 4:3 Alignment Mode. The pat-
tern below will be displayed.
Note: Pressing <VIDEO> will toggle between the 4:3,16:9 (top, top-center, center & bottom) and 16 Point Ge-
ometry Alignment modes.
2. In the 4:3 Alignment Mode, pressing (V43C & V43
cause the geometry pattern to be displayed with 11 preset amounts of correction. Toggle through them until
you find the one with the straightest Blue 4:3 Lines. It may help to count the patterns as you cycle through
them. When you find the pattern with the straightest Blue 4:3 Lines, press <VIDEO>. The Top 16:9 Align-
ment Mode will then be activated as indicated by the Top Red 16:9 Line displayed in the pattern.
3. In the 16:9 Alignment Mode, pressing (V43C & V43
will cause the geometry pattern to be displayed with 15 different preset amounts of correction to the Red Line.
Toggle through them until you find the one with the straightest Red Line. Again, count the patterns as you
cycle through them. When you find the pattern with the straightest line, press <VIDEO>. The Top-Center
Red Line will be displayed in the pattern.
Select Straightest Red Line (Top)
<CH > or <CH >)
4:3 MODE
Select Straightest Blue Lines
<CH > or <CH >)
4:3 MODE
Page 39
(V43+ & V43++ <> or <>) will
(V43+ & V43++ <> or <>)