Table Of Contents - Sony XM-504Z Service Manual

XM-504Z
PROTECTOR OPERATION CHECK
Thermal Protect
1. Short across TH901 with the power on.
2. Verify that the protector is operated and LED901 illuminates
red.
3. Verify that the protector is released and LED901 illuminates green
when the short is removed.
4. Likewise, perform items 1 to 3 for TH902 and TH903.
Over Current Protect
1. Short between the positive and negative sides of the speaker
output terminal CN903 and CN904 (1/2) with the power on.
(Perform this shorting for each channel on FRONT and REAR.)
2. Verify that the protector is operated and LED901 illuminates
red.
3. Verify that the protector is not released and LED901 remains
red even when the short is removed.
4. Verify that the protector is released and LED901 illuminates green
when the power is turned off and then on again.
Offset Protect
1. Short between the +12V terminal of CN904 (2/2) and the BTL+
or BTL- of the speaker output terminal CN903 and CN904 (1/
2).
(Short between +12V terminal and BTL+ and between +12V
terminal and BTL-.)
2. Verify that the protector is operated and LED901 illuminates
red.
3. Verify that the protector is not released and LED901 remains
red even when the short is removed.
4. Verify that the protector is released and LED901 illuminates green
when the power is turned off and then on again.
2

TABLE OF CONTENTS

1. GENERAL
Connections ............................................................................. 3
2. DISASSEMBLY
2-1. Bottom Plate ........................................................................ 5
2-2. Main Board Section ............................................................ 6
2-3. Main Board ......................................................................... 6
3. DIAGRAMS
3-1. IC Block Diagram ............................................................... 7
3-2. Printed Wiring Board .......................................................... 8
3-3. Schematic Diagram -Amp Section- ................................... 9
3-4. Schematic Diagram -Power Section- ............................... 10
4. EXPLODED VIEWS
4-1. Heat Sink (Main) Section .................................................. 11
4-2. Main Board Section .......................................................... 12
5. ELECTRICAL PARTS LIST
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
........................................ 13