Fanimation old havana series Owner's Manual page 9

1. Determine approximate position of fan.
2. Locate stud in your wall.
3. For stud installation the top and bottom holes on
wall bracket will be used. These holes are on 11"
centers.
4. Position wall bracket on dry wall and mark hole
locations.
5. Drill two 5/32 pilot holes through drywall into
wooden stud.
6. Position wall bracket over pilot holes and mount
with two #12 x 3 wood screws provided.
Concrete Wall Installation Note
It is recommended that all four mounting holes are
used in concrete wall installations. Concrete wall
anchors are not provided.
Mounting Motor Assembly to Mounted Wall Bracket
1. After you have successfully assembled the Wall
Bracket to the wall, you are ready to mount the Mo-
tor Assembly to the Wall Bracket.
2. Secure Hex Bolt and washer to the Wall Bracket
(Fig 24).
3. Position the Motor Assembly onto the Wall
Bracket.
4. Using a 5/16 x 2½ bolt and washer, fasten the
Motor As sem bly to the wall bracket.
5. Tighten with an adjustable wrench. Do not over-
tighten.
6. Insert plastic screw caps into the four holes on the
wall bracket, this will hide any screw heads.
Mounting Wall Bracket to Wall
#12-3"
Screws (2)
Plas tic
Cap
Wall
Brack et
5/16 x 2½
Bolt & Washer
Motor
As sem bly
Hex Bolt
& Washer
13
Stud
Plas tic
Cap
Fig. 23
Wall
Brack et
Fig. 24