Preparing The Handset; Inserting The Supplied Batteries And Closing The Battery Cover; Connecting The Charging Cradle And Charging The Batteries - Siemens Gigaset C470 IP Installation Manual

6
1

Inserting the supplied batteries and closing the battery cover

A
Insert the battery compartment
cover into the notches at the top of
the battery compartment.
B
Then press the battery compart-
ment cover until it clicks into place.
>
The display is protected by a plastic film. Please remove the protective film!
2

Connecting the charging cradle and charging the batteries

B

Preparing the handset

>
Observe the
sequence (A, B)!
A
>
Check the polarity when inserting the batter-
ies (see symbols in or on the battery com-
partment).
>
Only use the recommended rechargeable
batteries.
Once the batteries have been inserted, the
handset switches on automatically.
>
Place the handset in the charging cradle and
wait until the batteries are fully charged.
>
Do not put the handset back in the charging
cradle until the batteries are fully dis-
charged through use.
>
After the first battery charge and discharge,
you may place your handset in the charging
cradle after every call.
>
The battery charging status is displayed in
the idle display: = e V U (flat to full).
A
B