Connections On The Back Of The Device - Siemens SISTORE MX Installation Manual

Description of SISTORE MX 3G / MX 3G DVD
7.2

Connections on the back of the device

22
Siemens Building Technologies
Fire Safety & Security Products
Fig. 7 Back side of SISTORE MX 3G / MX 3G DVD
Damage to the device and impairment of electrical safety
When voltages are applied to the digital inputs/outputs the device may be
damaged and electrical safety may be impaired.
CAUTION
Do not apply voltage to the digital inputs (7) and the alarm inputs (6).
Do not apply voltages higher than 24 V to the digital outputs (7).
1 Power supply unit
with fan
2 Video output 4 video outputs, 50/60 Hz
Connection for 75-Ohm BNC cable
Connect the same type of unit here as that on the video inputs (PAL, for
example), since otherwise it is not possible to operate the video outputs.
3 Video input IN 16 video inputs
Connection for 75 Ω BNC cable
4 Video input LOOP 16 loop-throughs
Connection for 75 Ω BNC cable
5 Audio 16 audio inputs (currently not supported)
4 audio outputs (currently not supported)
6 Alarm 16 alarm inputs
7 Digital 4 digital inputs
4 digital outputs
8 RS485 2 ports (ports 3 and 4 are used)
Transparent data channels for control of pan/tilt cameras, CKA48xx
control panel or MX multichannel box.
NOTE:
The software interface Com1 corresponds to port 3.
The software interface Com2 corresponds to port 4.
9 DVI-D For connecting a monitor (digital)
10 DVI-I For connecting a monitor (digital/analog)
NOTE:
If a monitor is connected using a VGA cable, an adapter is required.
11 LAN 2 x 1 Gigabit network port for a LAN cable (RJ45 network cable)
12 USB Connection of 4 USB-enabled devices
(e.g. USB-ISDN modem, printer, mouse, keyboard, DVD burner)
Please note:
The operation of external USB hard drives as a memory expansion is not
allowed for technical reasons.
13 ON / OFF Switching the unit on and off
14 Power supply 110 – 240 V AC, 50/60 Hz, max. 150 W
02.2009