If Movement Of The Monitor Has Been; Dismounting The Unit - Sony xav-7w Operating Instructions Manual

If movement of the monitor
has been impeded during the
monitor setting
If movement of the monitor during opening
or closing has been impeded by the gear shift
lever or another obstacle, follow the steps
below to set again.
1
Set the ignition key of the car to
OFF.
Take off obstacle .
2
Press the bottom of the monitor
frames to tilt the monitor forward.
Do not touch nor press the remote sensor nor
monitor display.
Tip
To tilt the monitor forward smoothly, press the
designated position by your thumbs of both hands
while putting your forefingers at the back side of
the monitor.
3
Set the ignition key to ON and
press the Reset button on the unit.
(See "Resetting the unit" on page 6.)
Note
When the Reset button is pushed, the memorized angle
is reset to the status of your purchase.

Dismounting the unit

1
Press and hold OFF for more than 2
seconds to turn off the unit.
2
Insert the supplied tool between
the unit and the frame, and rotate
90° to release the hidden
mounting spring. Repeat on the
opposite side and remove the
frame.
10 mm
90°
continue to next page t
47