Download  Print this page

Advertisement

1
A
Ethernet
Can network functions be used
with the PC (server) without any
problem?
Yes
Is the Link LED of the Ethernet
terminal on the server side lit?
Yes
B
Is the MAC Address [00:e0:36:**:**:**]
displayed on the network Setup
screen?
Yes
Is the HMG Setup correctly set?
Yes
Can the server be selected (not
grayed out) from the PDP?
C
Yes
Are the properties of the files
displayed on the Factory screen?
Yes
Defective decoding section of the
D
BCM7404.
Replace the MAIN BLOCK Assy.
[HMG] How to enter DTB Service menu
Note: Use the remote control unit that supports Factory mode, because the DTB Service menu is accessible from Factory mode.
Step 1: Press the FACTORY key on the remote control unit to display the INFORMATION screen of Factory mode.
Step 2: Press the MUTING key on the remote control unit 4 times to display the INITIALIZE screen.
Step 3: Press the j key on the remote control unit twice to display the "DTB SERVICE MODE (+)" indication at the bottom of the screen.
E
Step 4: Press the ENTER/SET key on the remote control unit to display the "MODE SHIFT <=>: No" indication at the bottom of the screen.
Step 5: Press the k or l key on the remote control unit until the "MODE SHIFT <=>: YES" indication is displayed at the bottom of the screen.
Step 6: Press and hold the ENTER/SET key on the remote control unit pressed for 5 seconds or more to activate DTB Service menu.
The Home Media Gallery (HMG) Service menu is indicated below:
Top page of DTB Service menu
F
52
1
2
No
Defective network board of the PC.
No
Is the cable OK?
Yes
Defective Ethernet section on the
MAIN BLOCK Assy.
No
The data specific to the MAIN
BLOCK Assy have been deleted.
No
Improper HMG Setup.
No
Is the PDP recognized by the
server as a device?
Yes
Can the files on the server be
recognized?
Yes
Defective decoding section of the
BCM7404.
No
Defective Ethernet section of the
BCM7404.
Home Media Gallery Service menu
KRP-M01
2
3
No
Problem with the cable.
Replace the MAIN BLOCK Assy.
Replace the MAIN BLOCK Assy.
No
Check the settings of the server
again.
No
Check the settings of the shared
folder for the server again.
Replace the MAIN BLOCK Assy.
Replace the MAIN BLOCK Assy.
3
4
Content data
Ethernet connection
information
USB device information
4

Advertisement

Table of Contents

   Related Manuals for Pioneer krp-m01

Comments to this Manuals

Symbols: 0
Latest comments: