Download  Print this page

Advertisement

1
A
[Common to the DTVs 1 and 2]
How to Display the DTB Service Menu
As you can display the DTB Service Menu from Factory mode, you should have a remote control unit that supports Factory
mode.
Step 1: Press the FACTORY key on the remote control unit to display the INFORMATION screen in Factory mode.
Step 2: Press the MUTING key on the remote control unit 4 times to display the INITIALIZE screen.
Step 3: Press the j key on the remote control unit twice so that DTB SERVICE MODE (+) is displayed at the bottom of the
screen.
Step 4: Press the ENTER/SET key on the remote control so that MODE SHIFT <=> :No is displayed at the bottom of the
screen.
Step 5: Press the k or l key on the remote control so that MODE SHIFT <=> :YES is displayed at the bottom of the screen.
B
Step 6: Press the ENTER/SET key on the remote control unit for 5 sec or more to display the DTB Service Menu.
Top page of the DTB Service Menu
C
Digital
: Service menu for digital terrestrial broadcast reception
Satellite : Service menu for digital satellite broadcast reception
How to Change the LNB Voltage on the DTV Service Menu
On the Satellite screen of the DTV Service menu below, move the cursor to LNB POWER by using the j key
on the remote control unit then change the LNB voltage, using the k or l key.
D
The LNB voltage values are as shown below:
V: 13 V (Typ.)
H: 18 V (Typ.)
Vup: V+1 V
Hup: H+1 V
E
F
46
1
2
KRP-M01
2
3
3
4
4

Advertisement

Table of Contents

   Related Manuals for Pioneer krp-m01

Comments to this Manuals

Symbols: 0
Latest comments: