Gram OM 62-00 T Instruction Manual page 20

- The hardness is not selected
properly; too little salt is being
used.
- Salt loss
Possible causes
- Smell of new machine
- Filters are dirty
- Dishes stand in the machine for a
few days without being washed
Possible causes
- Excessive use of detergent when
water hardness is low, cleaning
temperature is too high
Possible causes
- The lid of the salt container is not
closing properly.
- Check the set values with the stated values from the local
water board.
- Check whether the lid of the salt container is firmly closed.
Use the funnel to pour in special salt. Begin the pre-wash
programme right after filling in salt. After the program is
complete, check whether the lid may have loosened.
Smell
How to fix these problems
- The smell of a new machine disappears after a few washing
runs.
- Clean all strainers and filters as described in the manual.
- Remove coarse dirt under running water and carry out the
pre-wash program with an interval of 2 days without a
detergent. Close the door to avoid the development of
smells.
Milky appearance or blue
shimmering deposit on the
glasses (glass corrosion)
How to fix these problems
- Choose a programme with a low temperature and add a
smaller amount of detergent. Check the set water hardness
against the stated values from the local water board.
Rust stains, destruction
of the surface
How to fix these problems
- Salt can destroy metal surfaces and cause rust damage.
- Check whether the lid of the salt container is firmly closed.
Use the funnel to pour in special salt. Begin the pre-wash
programme right after filling in salt. After the program is
complete, check whether the lid may have loosened.
18