Other Functions
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press the select button repeatedly
until “BAL,” “FAD,” “LPF” or “SUB”
appears.
Each time you press the select button, the
item changes as follows:
1
t MID*
1
t HI*
1
t
LOW*
BAL (left-right) t FAD (front-rear) t
2
3
t
LPF (low pass filter)*
*
2
4
t
SUB (subwoofer volume)*
*
AUX (AUX level)*
5
*1 When EQ3 is activated (page 18).
*2 When “SUB” is selected (page 17).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4 The volume level is adjustable between –10
and +10 steps. (Below –10, “ATT” is displayed.)
*5 When “AUX–ON” is activated.
2
Rotate the volume control dial to
adjust the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT) on the card remote
commander.
After “ATT-ON” momentarily appears,
“ATT” appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).