Specifications - Makita GA4030 Instruction Manual

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Switch lever
4-1. Wheel guard
4-2. Screw
4-3. Bearing box
5-1. Wheel guard
5-2. Bearing box
5-3. Screw
5-4. Lever

SPECIFICATIONS

Depressed center wheel diameter
Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For Model GA4030
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
Explanation of general view
6-1. Screw
6-2. Lever
7-1. Lock nut
7-2. Depressed center grinding
wheel/Multi-disc
7-3. Inner flange
8-1. Lock nut wrench
8-2. Shaft lock
10-1. Lock nut
Model
Spindle thread
)
0
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 96 dB(A)
WA
value (tri-axial vector
2
) : 7.0 m/s
h,AG
2
GA4030
100 mm
M10
11000 min
266 mm
1.7 kg
ENE048-1
The declared vibration emission value may also be used
in a preliminary assessment of exposure.
The declared vibration emission value is used for main
applications of the power tool. However if the power tool
ENF002-2
is used for other applications, the vibration emission
value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG102-3
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG208-5
For Model GA4530
sum) Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
3
10-2. Abrasive cut-off wheel/diamond
wheel
10-3. Inner flange
10-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
11-1. Exhaust vent
11-2. Inhalation vent
GA4530
115 mm
M14
-1 -1
11000 min
266 mm
1.8 kg
/II
) : 85 dB(A)
pA
) : 96 dB(A)
WA
Wear ear protection
GA5030
125 mm
M14
-1
11000 min
266 mm
1.8 kg
ENG102-3