Adjusting Steering Bearing Play; Adjusting The Steering Angle - Ducati Multistrada 1000ds Workshop Manual

Hide thumbs Also See for Multistrada 1000ds:
Table of Contents

Advertisement

sezione / section
H 2
5
6
11
A
edizione/edition 08-03
Mototelaio
Frame
Registrazione gioco
cuscinetti di sterzo
Note
Per la registrazione del gioco
dei cuscinetti di sterzo seguire quanto
riportato alla sezione D 4.
Qualora non si risolvessero i problemi
riscontrati, verificare lo stato d'usura
dei cuscinetti di sterzo (5) e (6)
eventualmente sostituirli come
riportato al paragrafo "Smontaggio
componenti cannotto di sterzo" di
questa sezione.
Registrazione sterzata
Allentare i dadi (12).
Allentare i grani (11) di registrazione
su entrambi i lati della base di sterzo.
Munirsi di uno spessore calibrato (A)
di 15 mm, inserito sul fodero della
12
forcella, nella parte più alta vicino alla
base di sterzo, oppure usare un
calibro.
Sterzare il gruppo forcella verso
destra fino a portare a contatto lo
2
spessore (A), con il tubo superiore del
LOCK
telaio.
Portare il grano (11) di registrazione
opposto al lato della sterzata, a
contatto con il fermo sul cannotto di
sterzo.
Applicare frenafiletti sulla filettatura
dado (12).
Mantenendo fermo il grano (11),
bloccare il dado (12).
Ruotare il gruppo forcella verso il lato
opposto: registrare allo stesso modo
l'altro grano e bloccare il relativo
dado.
Adjusting steering
bearing play
Note
See Section D 4 for steering
bearing play adjustment.
If the problem persists, inspect the
steering bearings (5) and (6) for wear
and replace as required. The
replacement procedure is detailed in
paragraph "Disassembling the
steering tube components" in this
Section.
Adjusting the steering
angle
Loosen the nuts (12).
Loosen the adjusting dowels (11) on
bottom yoke sides.
Fit a 15-mm feeler gauge or a
calibrated shim (A) into the fork outer
sleeve.
Turn the fork assembly to the right
until the shim (A) is against the upper
frame tube.
Bring the adjusting dowel (11)
opposite to the steering side against
the headstock stop.
Apply threadlocker to the nut thread
(12).
Hold the dowel (11) and tighten the
nut (12).
Turn the fork assembly to the left
side. Adjust the other dowel as
described above and then tighten the
nut.
A
B
C
D
E
F
G
H
L
M
N
P
7

Advertisement

Table of Contents
loading

Table of Contents