Maintenance; Mains Plug Replacement - Black & Decker KS1300 Instruction Manual

ENGLISH
Using the sight guide (fig. G)
The tool is equipped with a sight guide for
straight cutting (25) and for 45° bevel cutting
(26).
•
Adjust the sight guide as described below.
•
Align the left edge of the guides (25) or (26)
with the cutting line (27).
•
Keep the sight guide aligned with the cutting
line while sawing.
•
Work with the shoe pressed against the
workpiece.
Adjusting the sight guide
•
Make a test cut halfway through a piece of
scrap wood.
•
Withdraw the saw so the cutting line (27)
becomes visible.
•
While keeping the saw in this position,
loosen the sight guide on the saw shoe as
shown.
•
Align the 0° mark (25) on the sight guide with
the cutting line (27). When adjusting for 45°
bevel cuts, align the 45° mark (26) on the
sight guide with the cutting line.
•
Secure the sight guide using the screw (28).
Dust extraction (fig. H)
An adaptor is required to connect a vacuum
cleaner or dust extractor to the tool.
•
Insert the dust extraction adaptor (29) into
the saw dust outlet (10).
•
Connect the vacuum cleaner hose (30) to the
adaptor.

Maintenance

Your Black & Decker corded/cordless
appliance/tool has been designed to operate
12
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance
on corded/cordless power tools:
•
Switch off and unplug the appliance/tool.
•
Or switch off and remove the battery from the
appliance/tool if the appliance/tool has a
separate battery pack.
•
Or run the battery down completely if it is
integral and then switch off.
•
Unplug the charger before cleaning it. Your
charger does not require any maintenance
apart from regular cleaning.
•
Regularly clean the ventilation slots in your
appliance/tool/charger using a soft brush or
dry cloth.
•
Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or
solvent-based cleaner.
•
Regularly open the chuck and tap it to
remove any dust from the interior (when
fitted).

Mains Plug Replacement

If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal of
the new plug.
•
Connect the blue lead to the neutral terminal.
•
If the product is class l (earthed), connect the
green / yellow lead to the earth terminal.