Related Manuals for Globalsat GB-1000
Summary of Contents for Globalsat GB-1000
- Page 1 Power On/Off OK/Setup or (hold 3 sec.) or Backlight Pause (in training) Page Down Page Up GB-1000 User Manual v2.0...
- Page 2 Q1. How to start training and check your training data? [Power On] [OK] 3 sec. The satellite icon will flash while locating. * AVERAGE SPEED TOTAL ACCUMULATED DISTANCE * TRIP DISTANCE TRIP TIME * MAXIMUM SPEED CALORIES current time of day ** MAXIMUM CADENCE ** AVERAGE CADENCE ** CURRENT CADENCE...
- Page 3 Q2. How to configure and pair your device? [OK] [OK] 3 sec. Please enter configuration [Page Down] or [Page Up] to [Page Down] or [Page Up] to mode at START page. swap unit system. select language [OK] [OK] [OK] [Page Down] or [Page Up] to [Page Down] or [Page Up] to [Page Down] or [Page Up] to select gender...
- Page 4 Q3. How to use GO-TO function? A3 Step 1: Save Waypoint You cannot save one waypoint if GO-TO function is in use. [Page Down] 3 sec. GPS fixed ? [Page Down] / [Page Up] waypoint can only be saved when GPS is located save waypoint? skip waypoint saving? [OK]...
- Page 5 Q4. How to do total distance reset and factory reset? [OK/Setup] to [OK/Setup] to cancel reset [Page Down] action and re-confirm & [Page Up] Total Distance go back 3 sec. Reset Start page You can only reset TOTAL DISTANCE RESET? at start page.
- Page 6 Q5. How to reboot the device? A5: Hold [Power On/Off] for 8 seconds to do hardware shutdown and then turn on again to reboot the device. Q6. Other questions Q6.1. How to pause during your training? A6.1: Just press [OK/Setup] when you are in training and current training status will be held.
- Page 7 Q7. Where to download the “Training Gym Pro” PC software? A7: You can visit our official website “http://www.globalsat.com.tw/” and search “GB-1000” to download from product page. Q7.1. What can PC software do? A7.1: PC software can help you check your training data by showing training files, training information, data graphs...etc.
- Page 8 Q11. How to check firmware version? A11: Press [Page Up] two times in “START”page and you can see the firmware version. (ex: version 1308261) You can go back to “START”page by pressing [Page Up] two times in this page. GB-1000...
Need help?
Do you have a question about the GB-1000 and is the answer not in the manual?
Questions and answers