access the Internet so you do not have to enter them manually. Most home networks are Dynamic
Some networks require a Static IP address. If your network requires a Static IP address, you must
enter the IP address, subnet mask, gateway, and DNS values manually on your product Cable
Setup Screen when you set up the network connection. To get the IP address, subnet mask,
gateway, and DNS values, contact your Internet Service Provider (ISP). If you have a Windows
computer, you can also get these values through your computer.
You can use ADSL modems that support DHCP if your network requires a Static IP address. ADSL
modems that support DHCP also let you use Static IP addresses.
7.1.2 Wired Network Settings
Set the network connection to use Internet services such as perform software upgrades.
Automatic Network Setup
Use the Automatic
To set up your product cable network connection automatically, follow these steps.
How to set up automatically
Go to the
Select Wired, press [
The network test screen appears and verifies the network connection. When the connection has
been verified, the
If the connection process fails, check the LAN port connection.
If the automatic process cannot find the network connection values or if you want to set the
connection manually, go to the next secton,
when connecting your product to a network that supports DHCP.
], and then press [
"Internet is connected
successfully." message appears.