Basic Working Techniques - Husqvarna 570BTS Operator's Manual

• The powerful currents of air can move objects at such
a speed that they can bounce back and cause serious
eye injuries.
• Do not direct the air jet towards people or animals.
• Stop the engine before assembling or dismantling
accessories or other parts.
• Do not use the machine in bad weather, such as
dense fog, heavy rain, strong wind, intense cold, etc.
Working in bad weather is tiring and can lead to
dangerous conditions, e.g. slippery surfaces.
• Minimise the blowing time by lightly wetting dusty
areas or using spray equipment.
• Make sure you can move and stand safely. Check the
area around you for possible obstacles (roots, rocks,
branches, ditches, etc.) in case you have to move
suddenly. Take great care when working on sloping
ground.
• Never put the machine down with the engine running
unless you have it in clear sight.
• Engine exhaust fumes contain carbon monoxide,
which can cause carbon monoxide poisoning. For this
reason you should not start or run the machine
indoors, or anywhere that is poorly ventilated.
• The blower must not be used while on a ladder or
scaffolding.
1154033-38 Rev.2 2011-08-01
SAFETY INSTRUCTIONS
•

Basic working techniques

•
•
•
•
•
•
•
CAUTION! Do not use the machine unless you are
able to call for help in the event of an accident.
!
WARNING! Watch out for thrown objects.
Always wear eye protection. Stones,
rubbish, etc. can be thrown up into the
eyes causing blindness or serious injury.
Keep unauthorised persons at a
distance. Children, animals, onlookers
and helpers should be kept outside the
safety zone of 15 m. Stop the machine
immediately if anyone approaches.
!
WARNING! Always stop the engine
before cleaning.
This blower is a backpack type, and is carried using a
shoulder harness while operating. It is operated and
controlled with the handle on the tube using the right
hand.
The speed of the air jet is regulated by means of the
throttle. Select the speed best suited for respective
tasks. You can set the throttle position using the "stop
switch" and by doing so not need to hold your finger
on the throttle all the time you are using the blower.
Full throttle is obtained when the control is held back
fully.
Check that the air intake is not blocked, for example,
by leaves or rubbish. A clogged air intake reduces the
machine's blowing capacity and increases the
engine's working temperature, which can result in
engine failure. Stop the engine and remove the object.
Be aware of the wind direction. Work with the wind to
make your work easier.
Using the blower to move large piles is time
consuming and creates unnecessary noise.
Keep a good balance and a firm foothold.
When work is finished the machine should be stored
vertically.
–
English 11