Table of Contents
Advertisement
Quick Links
□
Tower and Rack-Mount
Convertible UPS
User's Manual
750/1000/1500/2200/3000
Table of Contents
1
Introduction ------------------------------------------------------------------------------------2
2
IMPORTANT SAFETY INSTRUCTION -------------------------------------------------3
2.1
An Important Notice ------------------------------------------------------------3
2.2
Storage Instruction --------------------------------------------------------------4
3
SET UP -----------------------------------------------------------------------------------------5
3.1
Inspection ------------------------------------------------------------------------5
3.2
Place the UPS Properly---------------------------------------------------------5
3.3
Unpacking------------------------------------------------------------------------6
3.4
Selecting Installation Position -------------------------------------------------7
3.5
UPS Setup------------------------------------------------------------------------7
3.6
Tower Setup ---------------------------------------------------------------------8
3.7
Rack-Mount Setup --------------------------------------------------------------9
3.8
UPS Front Panel--------------------------------------------------------------- 11
3.9
LCD Display Panel ----------------------------------------------------------- 12
3.10
UPS Rear Panel --------------------------------------------------------------- 13
4
INSTALLATION --------------------------------------------------------------------------- 18
4.1
Connect Utility and Load ---------------------------------------------------- 18
4.2
Connect Network Surge protection ----------------------------------------- 19
4.3
Connect Computer Interface Port ------------------------------------------- 19
4.4
REPO Switch ------------------------------------------------------------------ 20
5
OPERATION -------------------------------------------------------------------------------- 21
5.1
Turn on the UPS -------------------------------------------------------------- 21
5.2
Turn Off the UPS ------------------------------------------------------------- 21
5.3
Plug-in Charge ---------------------------------------------------------------- 21
5.4
Auto-Restart ------------------------------------------------------------------- 22
5.5
Alarm Silence------------------------------------------------------------------ 22
5.6
Self Test ------------------------------------------------------------------------ 22
6
UPS MAINTENANCE --------------------------------------------------------------------- 23
6.1
Battery Replacement---------------------------------------------------------- 23
6.2
How to Replace Battery ------------------------------------------------------ 24
6.3
Recycling the Used battery -------------------------------------------------- 26
7
Communication------------------------------------------------------------------------------ 27
7.1
DB-9 Connector --------------------------------------------------------------- 27
8
Optional Communication Cards ----------------------------------------------------------- 28
8.1
DCE (Dry Contact) card ----------------------------------------------------- 28
8.2
SNMP card of Megatec ------------------------------------------------------ 29
9
SPECIFICATIONS ------------------------------------------------------------------------- 30
9.1
120V ---------------------------------------------------------------------------- 30
9.2
230V ---------------------------------------------------------------------------- 32
1
Advertisement
Table of Contents
Summary of Contents for Janus 230V 750VA
-
Page 1: Table Of Contents
Table of Contents Introduction ------------------------------------------------------------------------------------2 IMPORTANT SAFETY INSTRUCTION -------------------------------------------------3 An Important Notice ------------------------------------------------------------3 Storage Instruction --------------------------------------------------------------4 SET UP -----------------------------------------------------------------------------------------5 Inspection ------------------------------------------------------------------------5 Place the UPS Properly---------------------------------------------------------5 Unpacking------------------------------------------------------------------------6 Selecting Installation Position -------------------------------------------------7 UPS Setup------------------------------------------------------------------------7 Tower Setup ---------------------------------------------------------------------8 Rack-Mount Setup --------------------------------------------------------------9 □ UPS Front Panel--------------------------------------------------------------- 11 LCD Display Panel ----------------------------------------------------------- 12 3.10 UPS Rear Panel --------------------------------------------------------------- 13... -
Page 2: Introduction
Introduction IMPORTANT SAFETY INSTRUCTION 2.1 An Important Notice The UPS featured with Tower/Rack Convertible design, Single AVR Boost and Single Buck, Pure Sine Wave Output, User’s Friendly LCD Display, Built-in customer Option Slot, Hot Swappable Battery, and USB/RS232 Communication 1. The UPS has its own internal energy source (battery). Should the battery interface, provides a flexible from factor for most of business critical file server, be switched on when no AC power is available, there could be voltage at minicomputers, network switches and hubs, etc. -
Page 3: Storage Instruction
SET UP 14. It should be recharged every 2-3 months if unused. If this is not done, then the warranty will be null and void. When installed and being used, the 3.1 Inspection batteries will be automatically recharged and kept in top condition. Inspect the UPS upon receipt. -
Page 4: Unpacking
3.4 Selecting Installation Position 3.3 Unpacking It is necessary to select a proper environment to install the unit, in order to 1. Take the UPS out of the PE foam. minimize the possibility of damage to the UPS and extend the life of the UPS. 2. -
Page 5: Tower Setup
3.6 Tower Setup 3.7 Rack-Mount Setup Step1 Stand alone unit Step2... -
Page 6: Ups Front Panel
Step3 3.8 UPS Front Panel Step4 Step5... -
Page 7: Lcd Display Panel
3.9 LCD Display Panel 3.10 UPS Rear Panel 1000 / 1500VA 120V Item Description Data Line Connectors Voltage Configuration Switch USB Port RS232 (DB-9) Port NEMA 5-15R Output Receptacles Cooling Fan 12A Input Circuit Breaker (1000 model only) 15A Input Circuit Breaker (1500 model only) NEMA 5-15P Input Power Core REPO 1. - Page 8 2200VA 120V(1920VA/1920W for UL) 3000VA 120V Item Description Item Description Data Line Connectors Data Line Connectors Voltage Configuration Switch Voltage Configuration Switch USB Port USB Port RS232 (DB-9) Port RS232 (DB-9) Port 15A Output Circuit Breaker for 6-1 15A Output Circuit Breaker for 6-1 20A Output Circuit Breaker for 6-2 20A Output Circuit Breaker for 6-2 NEMA 5-15R Output Receptacles...
- Page 9 750/ 1000/ 1500VA 230V 2200/ 3000VA 230V Item Description Item Description Data Line Connectors Data Line Connectors Voltage Configuration Switch Voltage Configuration Switch USB Port USB Port RS232 (DB-9) Port RS232 (DB-9) Port IEC-320-C13 Output Receptacles 10A Output Circuit Breaker for 6-1 Cooling Fan 10A Output Circuit Breaker for 6-2 7A Input Circuit Breaker (750 model only)
-
Page 10: Installation
INSTALLATION 4.2 Connect Network Surge protection 4.1 Connect Utility and Load Connect a 10 base-T / 100 base-T network cable with the RJ-45 network surge protection “IN” jack on the rear of the UPS. Connect from the “OUT” jack with network cabling to network equipment. First, connect the UPS with Utility, then plug the loads into the Outlets on the rear of the UPS. -
Page 11: Repo Switch
4.4 REPO Switch OPERATION The UPS is equipped with an Emergency Power Off (EPO) switch. The user must supply a means of interfacing with the EPO circuit to allow disconnecting 5.1 Turn on the UPS the UPS input feeder breaker to interrupt all sources of power to the UPS and connected equipment to comply with national and local wiring codes and 1. -
Page 12: Auto-Restart
UPS MAINTENANCE 5.4 Auto-Restart 6.1 Battery Replacement If the Input Power Cord is connected to the wall receptacle properly and Utility is back to normal, the UPS will automatically restart to provide energy to the When the UPS is started up or a self-test is executed, the Battery output after battery cut. -
Page 13: How To Replace Battery
6.2 How to Replace Battery STEP 3 STEP 1 STEP 4 STEP 2 1000/ 1500VA... -
Page 14: Recycling The Used Battery
2200/ 3000VA Communication 7.1 DB-9 Connector The UPS has a DB-9 (9 pin female) connector on the rear to allow UPS status communications with a computer running UPS software. The connection provides serial communication, On Battery and Low Battery signals. Table 4 DB-9 pin assignment DB-9 Pin... -
Page 15: Optional Communication Cards
8.2 SNMP card of Megatec Optional Communication Cards 8.1 DCE (Dry Contact) card 8.2.1. For installation, please refer to the user’s manual attached with the card. 8.2.2. Installation Position：Optional Slot ： 8.1.1 The pin assignments of 10-Pin Terminal Utility Abnormal Utility Normal AVR On Battery Low... -
Page 16: Specifications
SPECIFICATIONS Backup Time 9.1 120V Full Load 3”14 2”33 2”41 2”32 Model number 1000VA 1500VA 2200VA 3000VA Half Load 10”31 8”18 8”40 8”14 Power Rating, VA/W 1000VA/900W 1500VA/1350W 1920VA/1920W 3000VA/2700W Recharge Time 5 hours to 90% of rated capacity, after full discharge into resistive load Dimensions, W x D x H, in (mm) Environmental Unit... - Page 17 9.2 230V Environmental Model number 750VA 1000VA 1500VA 2200VA 3000VA Operating +32°F to + 104°C (0°C to + 40°C) Power Rating, VA/W 750VA/675W 1000VA/900W 1500VA/1350W 2200VA/1980W 3000VA/2700W Temperature Dimensions, W x D x H, in (mm) Storage Temperature +5°F to + 104°F (-15°C to + 40°C) Unit 440x405x88 440x405x88...
- Page 18 192321372001003...
Need help?
Do you have a question about the 230V 750VA and is the answer not in the manual?
Questions and answers